mmc: increase MMC SDHCI read status timeout

Otherwise,  ocassionally see errors like this:
  Flashing sparse image at offset 2078720
  Flashing Sparse Image
  sdhci_send_command: Timeout for status update!
  mmc fail to send stop cmd
  write_sparse_image: Write failed, block #2181088 [0]

This does not affect the actual writing speed, which is controlled by
the default value:
  CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT

It only increases the retries when reading:
  SDHCI_INT_STATUS
to avoid the timeout error.

Signed-off-by: Steve Rae <steve.rae@raedomain.com>
Reviewed-by: Stefan Roese <sr@denx.de>
Tested-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Tested-by: Jaehoon Chung <jh80.chung@samsung.com>

drivers/mmc/sdhci.c

@@ -127,6 +127,7 @@ static int sdhci_transfer_data(struct sdhci_host *host, struct mmc_data *data,
 #define CONFIG_SDHCI_CMD_MAX_TIMEOUT		3200
 #endif
 #define CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT	100
+#define SDHCI_READ_STATUS_TIMEOUT		1000
 
 static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
 		       struct mmc_data *data)
@@ -243,9 +244,9 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd,
 		if (stat & SDHCI_INT_ERROR)
 			break;
 	} while (((stat & mask) != mask) &&
-		 (get_timer(start) < CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT));
+		 (get_timer(start) < SDHCI_READ_STATUS_TIMEOUT));
 
-	if (get_timer(start) >= CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT) {
+	if (get_timer(start) >= SDHCI_READ_STATUS_TIMEOUT) {
 		if (host->quirks & SDHCI_QUIRK_BROKEN_R1B)
 			return 0;
 		else {