usb: musb-new: core: set MUSB_POWER_HSENAB in MUSB_POWER for host mode

This bit allows the MUSB controller to negotiate for high-speed mode when
the device is reset by the hub. If unset, Babble errors occur with
high-speed mass storage devices right after the first packet. This condition
is not caught by the interrupt handles in U-Boot, so no recovery is done,
and the USB communication is stuck.

To fix this, set the bit unconditionally, not only for
CONFIG_USB_GADGET_DUALSPEED but also for host-only modes.

Signed-off-by: Daniel Mack <zonque@gmail.com>

drivers/usb/musb-new/musb_core.c

@@ -942,9 +942,7 @@ void musb_start(struct musb *musb)
 
 	/* put into basic highspeed mode and start session */
 	musb_writeb(regs, MUSB_POWER, MUSB_POWER_ISOUPDATE
-#ifdef CONFIG_USB_GADGET_DUALSPEED
 						| MUSB_POWER_HSENAB
-#endif
 						/* ENSUSPEND wedges tusb */
 						/* | MUSB_POWER_ENSUSPEND */
 						);