| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768697071 |
- NODEID = 00 E0 4C 68 00 01
- ;ENDID = 00 E0 4C 68 FF FF
- VID = 10 EC
- DID = 81 25
- SVID = 10 EC
- SMID = 01 23
- ;Do not change following parameters without Realtek approval
- ;CONFIG0 = 07
- ;CONFIG1 = CF
- CONFIGx = 3C
- ;For add-on device, please set CONFIG3 to 60H
- ;CONFIG3 = 60
- ;CONFIG4 = 14
- ;CONFIG5 = 02
- ;If PXE is enabled, set spi_en (IO reg offset 0x56 bit 3 set to 1) to 1
- ;CONFIG5 = 0A
- ;PMC = C3 FF
- ;ROMBAR = 00
- ;LEDXCFG = High-Byte Low-Byte
- ;LEDX Bit 11: Low power mode enable
- ;LEDX Bit 10: Preboot enable
- ;Please make sure CONFIGx LED low power bit enabled
- ;(IO reg offset 0x53 bit 2 set to 0) before modifying LED low power mode or LED preboot
- ;LED0CFG = 02 01
- ;LED1CFG = 02 02
- ;LED2CFG = 02 08
- ;LED3CFG = 02 20
- ;LED Feature Functions
- ;Set BIT 0 to 0 : V1 led table.
- ;Set BIT 0 to 1 : V2 led table.
- ;BIT 1 to BIT 7 : Reserved
- ;LEDFEATUREFUNC = 60
- ROMCONF = 3F
- ;Bit 7-6 Boot Protocol
- ; 00 ==> PXE protocol
- ; 01 ==> RPL protocol
- ;Bit 5-4 Boot order (method)
- ; 00 ==> ROM disable
- ; 01 ==> Int 18h
- ; 10 ==> Int 19h
- ; 11 ==> PnP/BEV(BBS)
- ;Bit 3 Show Config Message
- ; 0 ==> Enable
- ; 1 ==> Disable
- ;Bit 2 Shift+F10 Menu Entry
- ; 0 ==> Enable
- ; 1 ==> Disable
- ;Bit 1-0 Show Config Time
- ; 00 ==> 3 Seconds
- ; 01 ==> 5 Seconds
- ; 10 ==> 1 Seconds
- ; 11 ==> 0 Second
- ;Serial Number in PCI Config Space
- SN = 00 E0 4C 68 00 00 00 01
- ;MDI swap
- ;MDI non-swap set to 00H, MDI swap set to 20H
- ;MDISWAP = 00
- ;Tx polarity swap
- ;BIT 7: P3 non-swap set to 0, P3 swap set to 1
- ;BIT 6: P2 non-swap set to 1, P2 swap set to 0
- ;BIT 5: P1 non-swap set to 0, P1 swap set to 1
- ;BIT 4: P0 non-swap set to 1, P0 swap set to 0
- ;BIT 0 to BIT 3 : Reserved
- ;TXPOLSWAP = 50
- ;DISFUNCXIOBAR = 00
- VERSION = 1.031
|
